Repeat with other side and the along the top with floral fabric. Your finished outside should look something like this:
Repeat with the other outside piece.
Next, fuse the fleece to the back side of your outside pieces. Trim up any corners or fleece that overlaps the edges. If you are a bit off in your measurements, it’s not going to matter much as long as you are square and both sides are the same.
Make sure your lining is the same size as your outside.
Now, here comes the zipper. I loath zippers, but this isn’t too bad to put in, especially because I left mine exposed as part of the design.
First, line up your zipper on the edge of your fabric, right sides together. Both ends of the zipper should hang off the fabric a little. Make sure the pull is off the end so you don’t have to mess with it while sewing.
Sew, with about ¼” seam allowance. You don’t even have to use your zipper foot if you don’t want to.
Ok, do the same for the other side.Once you open it up, it will look like this:
I really wish I had a picture of this next part, but I think I can explain it. You are going to flip down one of the sides of the front, so the edge that you have sewn to the zipper is exposed and the whole piece lies flat. Flip so one edge of the zipper is on top and ignore the other side you've already sewn to the zipper. Put lining piece along edge, right side down. Sew along the seam you already made. This is the trickiest part, but you can do it! Here's a diagram:
Turn to other side and repeat. You will end with with the lining looking just like the front:
Press flat. Keeping fabric in this configuration, topstitch along zipper, about 1/8" away from edge of fabric. Phew! That was the hardest part.
The handle. This is super simple after that whole zipper thing. First, fold your fabric in half, hot-dog style, then press. Then, turn in the edges of the fabric to the center fold and press (see photo). Then fold along first press and press again.
Topstitch along the edges (do the open side first) and you have your strap.
Baste your strap in place as shown. Only sew through the top layer and not the lining.
Open your zipper at least half way. Now you are ready to sew this bag into a bag. First, put right sides of the outside together and the right sides of the lining together. Sew around the outside, leaving an opening in the bottom of the lining for turning. Sewing the lining slightly smaller than the outside. My red lines on the photos below show were your sewing lines should be. Sew over the zipper (it should be folded in half). Go really slowly and hand-crank if necessary.
This is the last step before turning! You're almost done. Now, stand your bag upright and match the side seam to the bottom seam. You may need to clip the corners. It should form a right angle. Press.
Next, draw a line to make an triangle. Your line should be square with both your seams. Your line should be about four inches long.
Sew along your line and repeat with other three corners. Trim off the excess, leaving a 1/2" seam allowance. Turn your bag out through the hole in the lining. Press all the seams you can reach, then sew up the hole in your bag. I just realized I got so excited to finish my bag that I forgot to get a picture of this part. Gotta go take a picture now. . . Ok, back with it.
Hold the opening closed and sew across it. Trim your strings. You will probably do a better job than I did trimming yours. I was in a hurry. I get this kind of nervous excitement when I'm about to finish a project and I don't always pay attention to the finishing details. Since there happened to be a pair of scissors on my computer desk, I'm trimming them right now.
Tada! The finished bag, perfect for my trips.
